The first connector was the probe connector we’ve learned in class, we took off the inside of rope out and put in three conductive threads, then we make a knot around a pin and close it off using polymorph.

For my second connector(the bottom one of the image above), I paste copper tape onto a plastic stripe that is made out of a plastic sheet and on each side I put a paper clip into it. Then I solder the copper tape and the paper clip together.

For my third connector(the top one of the image above), I used the same method with the putting the conductive thread in but this time pulling the rope tighter so it makes a wave. On each side of the rope, I used a keychain ring and closed it using duck tape.

For my fourth connector(the bottom one of the image above), I did the same method as the rope we did in class but this time I used safety pins on the ends. I closed on safety pin with duck tape and another one using heat shrink tube.

It’s really great to find new fun ways to connect the circuit together.